ESTCube-LuNa early concept of operations

Hi there,

In an earlier blog post on ESTCube Lunar Nanospacecraft attitude and navigation, we promised to cover the mission operations. Here we are trying to figure out how to operate a nanospacecraft in lunar orbit without accessing agency-operated deep-space networks, or DSNs. It was back in 2006 when I decided to study Computer Science at Ventspils University College in Latvia (now Ventspils University of Applied Science, or VUAS). Only later did I learn about the Ventspils International Radio Astronomy Centre (VIRAC), which operates two parabolic antennas: Radio Telescopes 16 and 32, or RT-16 and RT-32. The corresponding numbers stand for their diameter in metres. Now, 18 years later, these dishes have been repurposed for two-way communications and are included in Sweden’s SSC Lunar Ground Network. We have been assuming RT-16 and RT-32 capabilities in designing ESTCube-LuNa operations and high-speed communications.

For low-speed communications in the ultra-high frequency, or UHF, band, we have assumed a Yagi–Uda antenna located at UT Tartu Observatory in Tõravere, Estonia, and a turnstile antenna located on ESTCube-LuNa. While more similar ground stations around the globe are necessary for continuous daily and monthly coverage, the on-board turnstile solution was selected to work in any direction, so we expect low-speed communication blackouts only when the nanospacecraft is behind the Moon. We hope the global radio amateur community would be interested in supporting the lunar mission in UHF.

For high-speed communications, the VIRAC infrastructure is critical, and covering the other side of the Earth is necessary (we will be looking for additional partnerships while securing the mission funding). Now, for mission analysis, we assume that one of the radio telescopes will be available for planned communications sessions and for radio frequency, or RF, ranging experiments to determine the E-sail orbital displacement. This means that RT-16 and RT-32 will be busy most of the time, hence the need for low-speed communications and for an optical on-board navigation solution.

The primary purpose of high-speed communications is to downlink the experiment data, which requires one antenna on the spacecraft. Since ESTCube-LuNa operates in a spin-stabilised mode, the ability to point the on-board patch antenna towards the ground station will be very limited. Therefore, we have placed patch antennas on four sides of ESTCube-LuNa for improved coverage. As a design example, we have used the EnduroSat X-band antenna, which takes up only one quarter of a single-unit cubesat face. On one of the sides, as shown in the top image, there are two antennas required for the RF experiment’s downlink and uplink.

The E-sail orbital displacement and RF ranging experiments will have to be carefully planned in advance.

Leave a Reply

Your email address will not be published. Required fields are marked *